65 lines
1.9 KiB
C
65 lines
1.9 KiB
C
#pragma once
|
|
|
|
#include <arduino-lmic/src/hal/hal.h>
|
|
|
|
//////////////////////////////////
|
|
////////////// Main //////////////
|
|
//////////////////////////////////
|
|
|
|
// The speed at which we should talk over our main hardware serial connection.
|
|
#define BAUD_PC 115200
|
|
|
|
// Multiple devices can use the same SPI data pin AFAIKT, but some libraries
|
|
// *cough* SD *cough* are too stupid to figure out which pin it is on their own.
|
|
#define PIN_SPI_DATA 9
|
|
|
|
// The 'done' pin to pulse to signal to the TPL5111
|
|
#define PIN_TPL_DONE 8
|
|
|
|
/////////////
|
|
/// RFM95 ///
|
|
/////////////
|
|
|
|
// Pin mapping
|
|
const lmic_pinmap lmic_pins = {
|
|
.nss = 10,
|
|
.rxtx = LMIC_UNUSED_PIN,
|
|
.rst = 9,
|
|
.dio = {2, 6, 7},
|
|
};
|
|
|
|
// The SPI chip-select pin for the RFM 95
|
|
#define PIN_SPI_CS_RFM95 10
|
|
|
|
/////////////////////////////////
|
|
////////////// GPS //////////////
|
|
/////////////////////////////////
|
|
|
|
// The *TX* gin of the GPS device.
|
|
// This is swapped because we receive the GPS device's message on our side on
|
|
// the RX pin, and the GPS device transmits messages on the TX.
|
|
#define PIN_GPS_RX 5
|
|
// The *RX* pin on the GPS device.
|
|
// This is swapped because where the GPs device is receiving, we aresending and
|
|
// vice versa.
|
|
// The TX / RX here are according to *our* side, not the GPS device's side.
|
|
#define PIN_GPS_TX 4
|
|
// The speed at which we should talk to the GPS device. Some GPS devices
|
|
// require a certain speed in order to use certain commands, so it's important
|
|
// that you check the datasheets for the device you're using.
|
|
// 9600 is the correct speed for a NEO-6M.
|
|
#define BAUD_GPS 9600
|
|
|
|
//////////////////////////////////
|
|
////////// microSD Card //////////
|
|
//////////////////////////////////
|
|
|
|
// The chip select pin that activates the connection to the microSD card over SPI.
|
|
#define PIN_SPI_CS_SD 3
|
|
|
|
// The filename on the microSD card to store data in.
|
|
#define SD_FILENAME "data.tsv"
|
|
|
|
// The filename on the microSD card to store debug information in
|
|
#define SD_FILENAME_DEBUG "debug.log"
|